Difference between revisions of "ONE/Command-line Interface CLI Guide"
From fd.io
< ONE
Florin.coras (Talk | contribs) |
|||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
== Introduction == | == Introduction == | ||
The vpp contain a set of commands to set and debug LISP. | The vpp contain a set of commands to set and debug LISP. | ||
| − | + | Access to VPP's CLI over telnet, assuming <tt>cli-listen localhost:5002</tt> is configured under <tt>unix</tt> in the startup.conf: | |
| + | <pre> | ||
| + | telnet 0 5002 | ||
| + | </pre> | ||
== Telnet LISP CLI == | == Telnet LISP CLI == | ||
Revision as of 17:36, 11 May 2016
Introduction
The vpp contain a set of commands to set and debug LISP. Access to VPP's CLI over telnet, assuming cli-listen localhost:5002 is configured under unix in the startup.conf:
telnet 0 5002
Telnet LISP CLI
Lisp enable
To enable lisp, use "lisp":
vpp# lisp enable
To disable lisp
vpp# lisp disable
Locator_set
To add new locator_set and locator, use "lisp locator-set add":
vpp# lisp locator-set add ls1 iface host-intervpp1 p 1 w 1
Where p is priority and w is weight.
To delete a specific locator_set, use "lisp locator-set del"
vpp# lisp locator-set del ls1
To display locator_set and locator:
vpp# show lisp locator-set
Locator-set Locator Priority Weight
ls1 6 1 1
Eid
To add new Eid address, use "lisp eid-table":
vpp# lisp eid-table add eid 6.0.1.0/24 locator-set ls1
To delete a specific eid address, use "lisp eid-table del"
vpp# lisp eid-table del eid 6.0.1.0/24 locator-set ls1
To display eid table:
vpp# show lisp eid-table
EID Locator
6.0.2.0/24 ls1
Map resolver
To add new map resolver, use "lisp map-resolver":
vpp# lisp map-resolver add 6.0.3.100
To delete a specific map resolver address, use "lisp map-resolver del":
vpp# lisp map-resolver del 6.0.3.100
