VPP/SecurityGroups

VPP Security Groups

Introduction

Features are tracked as they are developed in the following VPP-427.

Requirements

• Support classifiers/filters on any interface type (bridged / routed)
• Filter on IP-addresses with address mask or prefix length (IPv4 and IPv6)
• Filter on source and destination TCP/UDP port ranges
• Filter on source and destination L2 MAC addresses
• Support IPv6 with extension headers present
• Support fragmented packets and unknown transport layer headers
• Combinations of the above filters (e.g. MAC + IP)
• Filters on ingress and egress interfaces
• Stateful firewall. No application layer filtering.

Work list

Task	Owner	Priority	Status	Description
API definition	Ole	0	WIP
Ingress/Egress support for classifier		0
Support for L2/L3 interfaces		0
"Established" behaviour		1
Stateful firewall		1
Port ip_tables_firewall.py from Neutron as unit test		1

API

Add or delete egress IP access list:

define if_acl_add_ip_egress_rule
       u32 sw_ifindex;
       u8 allow;
       u8 is_add
       u8 is_ipv6;
       u8 src_ip_addr[16];
       u8 src_ip_prefix_len;
       u8 proto;
       u16 dst_min_port;
       u16 dst_max_port;
}

Add or delete ingress IP access list:

define if_acl_add_ip_ingress_rule
       u32 sw_ifindex;
       u8 allow;
       u8 is_add
       u8 is_ipv6;
       u8 dst_ip_addr[16];
       u8 dst_ip_prefix_len;
       u8 proto;
       u16 dst_min_port;
       u16 dst_max_port;
}

CLI

set interface input acl intfc <int> [ip4-table <index>] [ip6-table <index>] [l2-table <index>] [del] 
show inacl type [ip4|ip6|l2]

classify table [miss-next|l2-miss_next|acl-miss-next <next_index>] mask <mask-value> buckets <nn> [skip <n>] [match <n>] [del]
show classify tables [index <nn>]
classify session [hit-next|l2-hit-next|acl-hit-next <next_index>|policer-hit-next <policer_name>] table-index <nn> match [hex] [l2] [l3 ip4] [opaque-index <index>]

test classify [src <ip>] [sessions <nn>] [buckets <nn>] [table <nn>] [del]

set ip classify intfc <int> table-index <index>

set interface ip6 table <intfc> <table-id>

set interface l2 input classify intfc <interface-name> [ip4-table <n>] [ip6-table <n>] [other-table <n>]

set interface l2 output classify intfc <<interface-name>> [ip4-table <n>] [ip6-table <n>] [other-table <n>]

set ip source-and-port-range-check

show ip source-and-port-range-check vrf <nn> <ip-addr> <port>

Open Issues

• Security Group use case specific API. Done in VPP or control plane plugin?

References

• [1]
• [2]